Issue link: https://resources.ascented.com/i/1339546
Contents © 2020, ASCENT - Center for Technical Knowledge® v Chapter 9: Flat Pattern Environment .......................................................... 9-1 9.1 Creating Flat Patterns ..................................................................... 9-2 A-Side Definition ............................................................................... 9-4 Switching Between the Folded and Flat Environments ..................... 9-6 Defer Update ..................................................................................... 9-6 Unfolding the Flat Pattern ................................................................. 9-8 Unfolding Parts Without a Planar Face ............................................. 9-8 Overlapping Features in Flat Pattern ................................................ 9-9 9.2 Orienting Flat Patterns ................................................................. 9-10 9.3 Punch Representations ................................................................ 9-16 Punches Through a Feature ........................................................... 9-16 Embossed Features ........................................................................ 9-18 9.4 Bend Angle .................................................................................... 9-20 9.5 Flat Pattern Cleanup ..................................................................... 9-21 Adding Features to a Flat Pattern ................................................... 9-21 Copy to Flat Pattern ........................................................................ 9-22 Flat Pattern Features Panel ............................................................ 9-22 General Steps ................................................................................. 9-23 9.6 Exporting to DXF/DWG ................................................................. 9-27 Exporting Flat Patterns.................................................................... 9-27 Exporting Faces .............................................................................. 9-31 Practice 9a Flat Pattern I...................................................................... 9-34 Practice 9b Flat Pattern II .................................................................... 9-41 Practice 9c Flat Pattern of Curved Parts............................................ 9-47 Chapter Review Questions................................................................... 9-49 Command Summary ............................................................................. 9-52 Chapter 10: Lofted Flanges and Rips ....................................................... 10-1 10.1 Lofted Flange................................................................................. 10-2 10.2 Rip .................................................................................................. 10-7 Practice 10a Lofted Flanges and Rips................................................ 10-9 Practice 10b Point to Point Rip ......................................................... 10-21 Chapter Review Questions................................................................. 10-23 Command Summary ........................................................................... 10-25 Sample provided by ASCENT for review only All copying and reuse strictly forbidden.